A-A-110B
2. Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the supplier is responsible for the performance of all the inspections requirements of this CID. Except as otherwise specified, the supplier may utilize his own facilities or any commercial laboratory acceptable to the Government. The Government reserves the right to perform any of the inspections set forth in the Commercial Item Description, where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
3. Each lot of boxes shall be inspected for conformance to the requirements herein. Inspection shall be in accordance with MIL-STD-105 using the sampling plans specified below.
4. Visual characteristics - Inspection level S-4 with an Acceptable Quality level (AQL) of 4.0 percent defective. The sample unit shall be one box.
5. Dimensional characteristics - Inspection level S-2 with an Acceptable Quality level (AQL) of 4.0 percent defective. The sample unit shall be one box.
F. PACKAGING
Packaging, packing, labelling and marking shall be as specified in the contract or order.
G. NOTES
1. Applications for Copies of Documents Referenced Herein:
The issue date in effect on the date of invitation for bids or request for proposal shall apply.
1.1 MIL-STD-105 “Sampling Procedures and Tables for Inspection by Attributes” is available from Standardization Documents Order Desk; Building 4D; 700 Robbins Avenue; Philadelphia, PA 19111-5094.
1.2 ASTM D 3363 “Standard Test Method for Film Hardness by Pencil Test” is available from the American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.
2. Part Identification Number
The following part identification numbering procedure is for government purposes and does not constitute a requirement for the contractor.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business