A-A-2794
E. A locking follower plate and a centered reinforcing follower strip shall be used. The centered strip shall be 6.35 cm (2-1/2 inches) minimum, in width. Index cards shall rest on the follower assembly.
F. Instead of a centered strip, a follower rod may be used together with two reinforcing strips, one on each side of the rod. Each side strip shall be 1.27 cm (1/2 inch) minimum, in width.
G. The locking follower plate, the center reinforcing strip and the follower rod shall be made of corrosion resistant metal or plastic. Side strips shall be made of wood, plastic, corrosion resistance metal, binder’s board, chipboard or hard pressed fiberboard. Side strips shall be of the sufficient thickness to permit index cards to rest on the strip, not on the follower rod.
H. A centered reinforcing follower strip that is less than 6.35 cm (2-1/2 inches) in width may be used if the two side strips mentioned above are added.
I. All adjoining corners and edges of both the tray and cover shall be reinforced with cloth, or filament tape. The tape shall cover the entire outside corners, and shall extend a minimum of 9.5 mm (3/8 inch) on each side.
J. The tray and cover shall fit together and all sides of the cover shall extend down over the tray 2.54 cm (1 inch) + 3.2 mm (1/8 inch).
K. Both the exterior of the tray and cover shall be covered with matching agate marbleized paper. The paper shall extend a minimum of 1.27 cm (1/2 inch) over the edges into the sides and extend over the entire tray bottom.
L. The interior of the tray and cover shall be colored black.
M. The exterior of the tray and cover shall be black agate.
N. The tray shall include a follower assembly consisting of a locking follower plate on a rod or track. The locking follower plate shall be of sufficient size and construction to hold the specified size cards securely in place without damage. Corners and edges of the locking follower plate shall be smooth.
O. The tray shall have a label holder and pull made of a commercially acceptable corrosion resistant metal.
P. The label holder and pull shall be placed in the middle of the tray front and securely attached.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business