A-A-1030A
Finish. Shall be in accordance with normal commercial practice. All finishes shall level out to produce a smooth uniform surface and color, without runs, wrinkles, grit or areas or thin film. All parts shall be thoroughly coated with a commercially acceptable finish.
Color. Shall be as specified, or, if not specified, at the option of the manufacturer.
Dimensions. The overall dimensions shall not be less than 17.8 cm (7”) high and 20.3 cm (8”) deep and not more than 25.4 cm (10”) high and 30.5 cm (12”) deep. The width dimension shall be 40.6 + 2.54 cm (16 + 1”)
Base. The base of the racks shall be at least 0.437-0.493 mm (26 gage-0.0172” to 0.0194”) thick steel, in accordance with Manufacturer’s Standard Gage for Steel Sheets.
Dividers. The dividers shall be at least 0.569-0.645mm (24 gage-0.0224” to 0.0254”) thick steel, in accordance with the Manufacturer’s Standard Gage for Steel Sheets. If steel wire is used, it shall be not less than 3.76 mm (No.9-0.148”) diameter, (Birmingham Wire Gage). Removable dividers shall have a looking feature so they cannot be knocked out of position under normal usage.
Identification marking. Each rack shall be marked with the manufacturer’s name or trademark of such known character that the source of manufacture may be readily determined.
B. Workmanship. The method of fabricating, assembling, and finishing the rack shall be in accordance with the best commercial practices. All parts shall be free of burrs and sharp edges, and all corners rounded. Racks shall be free of any defects affecting appearance or serviceability.
3. QUALITY ASSURANCE:
A. Responsibility for Inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspection set forth in this commercial item description, where such inspections are deemed necessary to assure that supplies and services conform to prescribed requirements.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business